Hello again
over the weekend I tried my best to get familiar with my newly arrived Clarivox.
The theremin is a new instrument for me, but I thought I have done my homework and would get at least some stable pitch out of it.
I'm mainly interested in the traditional mode and the theremin as an instrument, since I come from the eurorack synth world...
(and I read enough to fear Thierry, so I didn't touch Modern Mode ;-))
I position myself, calibrate it, hold my hands still and I'm not able to get a stable pitch.
This is a short recording what I'm doing with my hands and an example of what happens when I connect the output to the tuner:
I really hold still, try not to breath and the pitch jumps around 40 Hz up and down.
Is there anything I'm doing wrong?
No special settings, register 0, no delay, no filter, wave/brightness 12 o'clock, traditional mode.
No big difference in the stability result if I try to tune the pitch antenna with the knob or keep it at 12 o'clock.
These are the other things I tried:
1) Updated firmware (which was already at 1.0.2)
2) Reset to factory defaults via software
3) Pitch null calibration according to the FAQ/manual
4) Other position in the room
5) Tried different power sockets
6) Tried three different rooms
7) Disconnected any electronic device in 3 different rooms
8) Disconnected wifi/turned of phone and removing anything which looks like it could interfere
9) Reattached the antenna multiple times
10) Turned it on/off multiple times, waited minutes/hours for it to warm up
11) Tried headphones only
12) Tried headphones only with multiple headphones
I'm out of ideas and feeling a little bit stupid and wonder if I really got a faulty unit?
I saw the other multi-page thread with the claravox problems, but this is nearly 1600 units later and there where no new postings in the last year.
I also checked http://aetherwellen-musik.de/Theremin-Instrumente-Instruments/Claravox-Centennial-CV-C-Theremin-Review-Improvement for any pitch related problems...
Any help is appreciated...